China plate heat exchanger plates enter to a new level

In the field of heat exchangers, people’s impressions of plates are always misunderstood as "too rigid and easy to fold". This is understandable, because the material of the plates is mostly stainless steel, even special materials, the hardness of itself is also placed there, and the corrugated plate after pressing, the hardness will be only strong or weak. But is the plate with higher hardness a high-quality plate?

Pay attention to everyone, Ruipute's plate can be bent to the angle of the figure while resisting stepping and pressing. This is the manifestation of the high yield, good elongation, and strength of the RPT plate. To put it more bluntly, it is under pressure. Just imagine, isn't it.

1. The raw material itself contains carbon and trace elements evenly distributed 2. The plate is pressed evenly 3. The smaller the damage caused during the stretching of the plate Can the effect on the picture be achieved? It's very simple. The first point is that we use the top domestic raw material manufacturers-Zhangpu and Baoxin to supply them. They are similar to Alfa, and many domestic companies use titanium steel; the second and third are the top priorities-molds.

Ruipute produces molds by itself. The heat treatment of molds is different from the surface penetration and modulation commonly used in China. We are the whole! It greatly prolongs the wear-resisting times and service life of the mold, so not only the plate, but the mold is also our product for sale! Technicians with many years of production experience can control the accuracy of the finished plate between 0.05-0.1mm under excellent molds and appropriate pressure, and produce plates with high yield, good elongation and good strength.