Qingdao Ruipute, which is a plate heat exchanger factory that quality equals to GEA brand

The brand of GEA plate heat exchanger has been widely favored in many food industries. There are not a few domestic users, so there are not a few domestic parts replacement suppliers. However, "success does not mean failure". Some customers bought GEA products or parts in China and directly "turned the powder into black". What is the matter?

First of all, the cost of the original GEA product itself is not low, because of the process and brand, which is why many suppliers turn their attention to the domestic market. But although the price is down, but the product, even less than satisfactory is not. Obviously not very complex working conditions, such as peanut butter heat transfer, itself may contain large particles, and then use a wide runner plate, compared with the original GEA products: plate heat transfer efficiency is extremely poor. Is the quality that is homebred really than cannot be imported?

No, in fact, many manufacturers have chosen the wrong supplier. All the time, the customers of ruiput have been full of praise for the quality of our factory, because the process of our factory has been able to withstand tempering:

First, let's look at a concept of efficiency: the Reynolds coefficient. In simple terms, the Reynolds number is the ratio between the inertia force and the viscosity of the fluid. The higher the Reynolds number is, the higher the heat transfer efficiency will be. However, under the same working condition, the viscosity of the medium is certain, so how does Ruipute make the medium have a higher inertial force on the plate?

We already talked about precision in the last video. Plate after special heat treatment of the mold pressing, high precision, is the national standard of 2-4 times! Domestic general manufacturers of 3-6 times! Because the accuracy of the national standard is only 0.2mm.Only the accuracy of the premise of the standard, to ensure the rigidity and hardness. More supporting points on the plate, without leaving any gap, the flow rate between the plates will be high, the natural Reynolds number will be high, and the heat exchange rate will be different from the same day!

Ruipute has a team of 17 engineers who can design the best scheme according to the specific working conditions. By changing the flow mode of the medium, the heat transfer rate can be improved to a higher level.

This is also the reason why we are confident that the quality is not inferior to the original GEA factory.